Pro-Fill on board battery watering system

Visit the Projects Gallery

I installed the Pro-Fill on board battery watering system.

Installation was pretty straight forward. First step was to remove the original caps on the batteries. Then install the Pro-Fill cap/fillers. After that was done then the manifold snapped onto the top of all 3 cap/fillers. This was probably the hardest part, I had to try to move the battery cables so I could slide the manifold into position and snap it down. Once this was done the next step was to cut the black tubing to the lengths I needed and connect all four of the manifolds. Then the main line filler tube was cut to length and attached. This line has the quick disconnect for the hand pump. All the attachments are of the barbed tube type, very easy, just slide the tube on.

Thats pretty much it. When its time to add water to the batteries just attach the hand pump to the fill line and the other end of the hand pump goes into the water and squeeze. You can hear the water flowing and each cell will only take as much water as it needs. All batteries filled at the same time.